Skip to content

Services · Installations

Electrical installations and control cabinets

Design and build of control cabinets, distribution boards and industrial automation — from the drawing and prefabrication through wiring, PLC programming, testing and commissioning, to the as-built documentation.

What we do

  • Design of control cabinets and distribution boards
  • Fitting of electrical and control components
  • Wiring to standards and to the schematic
  • PLC programming
  • Testing and commissioning of cabinets
  • As-built documentation and operating instructions
Control cabinet wiring made by SOWMAR
Control cabinet wiring made by SOWMAR

Our specialisations

Control cabinets

Complete machine control cabinets, built from the schematic and tested before they leave.

Distribution boards

Distribution boards built to the load and the layout you actually have.

Cross-connection cabinets

Cabinets for managing structured cabling, laid out so the next person can follow it.

Industrial automation

PLC control systems, including retrofits to machines whose original controls are past support.

Cabinets built to be worked on later

A control cabinet is built once and opened many times — usually by somebody else, usually at short notice, usually with the machine stopped. So the things that matter are not only that it works on day one: the wiring has to be traceable, the terminals labelled to match the drawing, and the drawing has to match what is actually in the cabinet.

We design and prefabricate control cabinets and distribution boards, fit the components, wire to the schematic, program the PLC where that is part of the scope, then test and commission. You get as-built documentation — not the design drawings with the changes left out.

What we build

Machine control cabinets, from a schematic you supply or from one we draw. Where the machine came from abroad without documentation, we work from the machine itself.

Distribution boards sized to the real load rather than a nominal figure copied from a similar site.

Control retrofits, where the original controls are obsolete and parts are no longer available. This is frequently cheaper than replacing the machine, and it is often the only route left.

Together with the mechanical work

Most of this work arrives attached to something else — a press overhaul, a machine rebuild, or a line being moved. Having the electrical and the mechanical side in one place means there is nobody to pass the fault to when the machine does not start.

That matters most at commissioning, which is where split responsibility normally shows up: the mechanical contractor says the signal is wrong, the electrical contractor says the actuator is. Here they are the same people.

Standards and documentation

Installations are built to the applicable standards, and the documentation is part of the delivery rather than something that follows later. Where the work is part of bringing a machine up to CE requirements, the electrical documentation feeds directly into that file.

Why choose SOWMAR?

Documented and warranted

Technical support after handover, and paperwork that matches what was actually built.

End to end

From the design through the build to commissioning and documentation.

Built to standards

Installations comply with the applicable standards and regulations.