Services · Installations
Pneumatics and utility lines
Design and installation of compressed air systems — pipework, connecting machines, pressure and tightness testing, and technical acceptance. Plus upgrades to systems you already have.
What we do
- Design and installation of new compressed air systems
- Installation of pneumatic pipework
- Connecting machines and equipment to the air system
- Upgrades to existing compressed air systems
- Pressure and tightness testing
- Technical acceptance and certification
Our specialisations
Leak detection
Finding where the air actually goes. On an older plant this is usually the cheapest efficiency measure available.
Tightness testing
Pressure and tightness tests on the installation, with the results documented.
End to end
From the design through to technical acceptance, without a second contractor in the middle.
Compressed air systems for industry
Compressed air is the most expensive utility in most plants and the one nobody measures. It is generated with a compressor that runs on electricity, and a significant share of that electricity leaves through leaks, through undersized pipework and through pressure set higher than anything on site actually needs.
We design and install compressed air systems, connect machines to them, and upgrade installations that have grown by accretion over the years. Pressure and tightness testing and technical acceptance are part of the job, not an extra.
Where the money goes
Leaks. A plant that has never been surveyed typically leaks a substantial fraction of what it generates, and it leaks continuously, including at night and at weekends when nothing is producing. Finding and fixing leaks is usually the cheapest thing on the list.
Undersized or extended pipework. Every branch added over the years drops a little more pressure. Eventually somebody compensates by turning the compressor up, which raises the cost of every cubic metre generated and makes every leak leak faster.
Pressure set too high. Set from the worst machine on the site, not from what the rest need. Sometimes the right answer is a local booster for the one machine rather than raising the whole system.
New installations
For a new system we start from what the air actually has to do: which machines, what consumption, what duty cycle and what quality of air. From that comes pipe sizing, the layout of the ring and the drop points, and where the treatment goes.
Installation is followed by pressure and tightness testing, technical acceptance and documentation. We do the same work on existing systems, where the object is usually to fix what has accumulated rather than to start again.
Together with the rest of the plant
Machines usually need air and power and a mechanical connection at the same time. We also handle electrical installations and control cabinets and the mechanical side, so connecting a machine does not need three contractors coordinating with each other through you.
Why choose SOWMAR?
Utilities as well as air
Compressed air, industrial electrics and connecting machines to process utilities, from one supplier.
Built to standards
Installations comply with the applicable standards and regulations.
Measured, not guessed
We work from pressure at the point of use, not from what the compressor gauge reads.
Related services
Electrical installations and control cabinets
Prefabrication of control cabinets and distribution boards, machine wiring, component fitting and commissionin…
3D design and FEA
We design machines, dies, welding and soldering tooling and spare parts. FEA calculations and fatigue assessme…
3D scanning of parts and machines
We scan parts with no documentation, machines for installation design, and components to be reproduced. A scan…